Aluminium and Stainless Steel Welding Torch Liner - 4m

Eliminate wire feed problems with a PA Combi Liner. The perfect MIG torch liner for welding aluminium or stainless steel. It offers reduced friction over that of a PTFE liner and improved length of life too thanks to the brass neck liner section. 

Available to buy in 3, 4 and 5m lengths we have everything for every torch length with regards to welding aluminium. This particular liner is genuine Binzel and made to exacting standards as you would come to expect from Binzel. 
Binzel original MIG torch liner for special wires - PA & brass special liner for those exotic filler wires designed to avoid contamination and allow easy feeding with the PTFE section of the liner.

Never trim the brass end of the combi-liner, ensure the brass heat sink coil fits right up against tip holder / contact tip.
The free end with the collet and "O" ring will require to be slid into position and the liner cap nut screwed into position.  When being used with aluminium filler wire the liner can sometimes be fed through the back of the torch Euro socket into the outlet of the drive rolls which may be beneficial to help prevent "bird nesting".