#3P T5 - Multi-Flame Hooked Nozzle to Get Round Pipes - Oxy / Propane 40-65mm
Standard Type 5 Mixer Thread.
Please Note This Is An Oxy / Propane Nozzle
Braziing & Silver soldering nozzle specifically designed for those awkward to access areas where you may need to join pipes such as close to a bulkhead / panel or wall. The largest hook nozzle has 11 flames designed to suit pipes from 40 to 65mm diameter.
For brazing smaller diameter pipes please see the other sizes in the range, the smaller nozzle sizes have a fewer number of heating flame cones designed for the correct heat spread required for smaller pipe diameters.
This largest hook brazing nozzle will screw directly into the Type 3 or Type 5 welding mixer allowing it to be used with Type 3 / Type 5 shank, the brazing nozzle has 11 heating flames which are focused on the same point towards the centre ensuring the tube / pipes to be joined may be heated from all sides, including the back which you cannot always get to. This hooked multiple outlet brazing nozzle is ideal for heating and ventilation engineers.
There are also oxy / acetylene versions available (Need high flow of DA therefore multiple DA cylinders).
The oxy / propane hook brazing nozzles do not have the flow "problem" associated with the acetylene version - simply because many heating and ventilation engineers use small portable fuel gas cylinders. The flow rate for the oxy propane version does need to be set correctly and with a sufficiently high enough flow otherwise the nozzle will extinguish with a bang!
Set the flame to a high enough flow so that one or two cones "dance" on an off the burner tube when the nozzle is burning without a pipe in place.
Designed to be used with pipe diameters of between 40 and 65 mm