Shield Master Flow Meter & Gas Economiser - A Single Unit with Tamper Proof Setting.

Take control of your shielding gas costs, you will cut your gas cost dramatically whether it is mixed gas or pure Argon whatever the shielding gas you use it may be saved without affecting weld quality thereby reducing the welding cost and making you more profit at the same time.  Fitting these Shield Master gas economiser flow meter units  will help to reduce what you spend on shielding gases saving you much more than reducing the cost of your welding wire by a few pence per kilogram.

The greatest benefit will be experienced when fitting these Shield Master units to each MIG / TIG welding point.  The economiser unit may be used at pipeline outlet points or fit them to the outlet of your regulator - ensure the flow meter is vertical.

The shorter your welding runs the more you will save, i.e. the more frequent the stop start the more you will save and these units will pay for themselves in 6 months then the money you save is extra profit.

Another positive feature of the Shield Master is that the flow adjustment is only possible with a key - to remove the plug - then a screw driver is required to adjust the required flow, once set the plug is replaced and locked in position so the flow cannot be increased.


Often many welders do not realise they could save so much gas / money by using so much less gas.  The gas economiser prevents the unwanted initial surge of gas associated with a traditional regulator, when the MIG trigger is pulled the solenoid valve opens and the back pressure delivers a surge of shielding gas which is a complete waste.  

Shield Master - Gas Economiser for Shielding Gases - Wall outlet point with built-in flow meter and lockable flow setting so it can not be tampered with.