High Flow CO2 & CO2 Mixed Gas Pre-Heater for fitting directly to CO2 cylinder
(Image shows Inert but fittings you get will be CO2)
Made in Germany, this high flow CO2 heater may be used for many applications besides welding because this gas pre-heater is rated for high pressure use at a flow rate of 24 cubic meters per hour which means that multiple welding applications may be operated from a single heater or use in the beverage and food industries where high flow "protective" gas blankets are required.
Traditional use for MAG welding with pure CO2 may result in the CO2 being withdrawn at such a rate as to freeze the regulator, this CO2 pre-heater is fitted directly to the CO2 cylinder valve with your CO2 regulator being fitted to the heater.
This is a large 200W high flow CO2 heater so is physically larger than most other CO2 heaters on the market, the purpose remains the same which is that to warm the gas before the gas enters the regulator. The CO2 heater has a 230 bar inlet bullnose and may be used with mixed gases or fitted with an adapter to screw direct to a CO2 cylinder.
The heater requires a standard 240V Ac connection / 13Amp socket. A 13amp 3 pin UK plug is fitted to the power cord.
This gas heater is available with "NEVOC" connections for use with 300bar cylinders.
Many inlet and outlet connections are available for use with lower cylinder gas pressures.
Higher flow 400Watt version available 100m3/hr