CWS Thermic Lance Holder with 3/8 BSP Inlet Connection - Manufactured in Cheltenham

Thermic Lance Holder - Collet fixing for 3/8 WP Packed Lances from 16.6mm up to 18mm diameter G3/8" inlet Connection  Collet item code PA3684

Thermic lance holder for "3/8" water pipe typically 16.6mm outside diameter packed thermic lances with plain ends and typically 3m long. Noz-Alls have our own extra life thermic lances which are 18mm in diameter and tightly packed with inner rods. Our lance holder will accomdate both lance diameters but once you try the 18mm you will probably never switch back. 

This top quality British made thermic lance holder with collet clamping hand tightening nut ring this lance holder has a 90 degree ball valve for quick action allowing full power to be applied quickly when required.

Inlet connection is G3/8 Right hand for the most common connection.
Spare rubber seals are available as are all other spares that you could ever need. 
Rubber seal item code PA3685
Spare collet 16.5 to 18mm item code PA3684
Spare collet nut item code PA3686
The new improved CWS lance holder is available with G3/8, G1/2 or G3/4 right hand threaded inlet connections.  

These thermic lances require a high flow rate to enable the lance to complete boring / cutting process therefore it is essential to use a high flow oxygen regulator such as the OR14 or the MR400.  The hose used for thermic lancing should be a large bore and unrestricted, Minimum bore 10mm diameter plus be sure to remove any normal hose check valves as the HCV will impede the oxygen flow and create an unnecessary  pressure drop.   For longer hose lengths 10m to 20m, and really those over 5m the use of 1/2" bore oxygen hose is important to ensure the correct flow.
To make working with a large bore hose acceptable it is possible to fit a short - 3m to 5m - "whip end" hose of smaller bore (10mm) to the larger bore hose (12 to 19mm) which then allows greater manoeuvrability and helps to reduce artisan fatigue.